Welcome to XROX Aerospace The sky is not the limit!!
Welcome to XROX Aerospace The sky is not the limit!!
Cart 0

MK3A Rebel Build — MK3A

MK3A Rebel (K0001) Build Part 5 - Final Assembly and Paint Prep

Build Elmers Wood Filler Finishing Kit MK3A Part 5 Rebel Stand XROX Aerospace

MK3A Rebel (K0001) Build Part 5 - Final Assembly and Paint Prep

MK3A Rebel (K0001) Build Part 5 - Final Assembly and Paint Prep

Read more →


MK3A Rebel (K0001) Build Part 3 - Booster Assembly and Finish Prep

Booster Build Elmers Wood Filler Finishing MK3A Part 3 Rebel

MK3A Rebel (K0001) Build Part 3 - Booster Assembly and Finish Prep

Part 3 of this blog series finishes the MK3A Rebel's booster section .  If you missed Part 2 of this series, it is available at this link. As stated in the assembly instructions provided with the kit, epoxy is required for kit assembly.  I use quick drying 5 minute epoxy, but any two part epoxy is fine. For Part 3, we will need: Fin can assembly from Part 2 of the blog series 9 inch body tube (Part #6) Chambered Baffle (Part #5) 0.25 inch screw eye (Part #2) During this series of steps, preliminary work is done to prepare...

Read more →


MK3A Rebel Stability

Barrowman Kit MK3A Rebel RockSim Stability

MK3A Rebel Stability

XROX Aerospace MK3A Rebel Stability Discussion

Read more →


MK3A Rebel (K0001) Build Part 2 - Fin can assembly

Build Fin Can Kit MK3A Motor Mount Part 2 Rebel

MK3A Rebel (K0001) Build Part 2 - Fin can assembly

Part 2 of this blog series shows the assembly of the fin can and motor mount.

Read more →


MK3A Rebel (K0001) Build Part 1 - Kit contents

Build Kit MK3A Part 1 Parts Rebel

MK3A Rebel (K0001) Build Part 1 - Kit contents

The MK3A Rebel kit comes in a long, corrugated box.  Inside the box are thirteen components of the kit, several printed sheet and the water-slide decal sheet..  The rocket uses standard "BT-60" size body tube and a 24mm tube for the motor mount.  The kit also contains an 18" plastic parachute kit, 2 screw eyes and a Kevlar shock cord.  This is where the similarity to old style low power rocket kits ends.  The rest of the kit parts are all 3D printed pieces.     The fin can and motor mount assembly have five pieces plus a spacer for 70...

Read more →